User guide

Chapter 2: Set up your job 27
Verify your job
It is important to verify that your job is free of problems. Label Studio checks
your job setup in three different ways to ensure accuracy:
 Automatically when defining parameters in the job file blocks.
 When you choose the Verify Job option.
 Automatically when running your job.
Parameters and
blocks
If you set a parameter in a way that is clearly wrong, Label Studio either beeps or
displays an error message. When you click OK to close a window, Label Studio
checks the whole window for any errors or conflicts. So you get instant feedback
and you can fix the problem.
Verify Job option Before processing, you should check the whole job for possible conflicts between
blocks by choosing File > Verify Job.
Label Studio will present a list of problems in a Browse Job Problems window.
When you select a problem to address, Label Studio can help you go to the
problem area in the job file. Label Studio will try to detect and report as many
problems as it can find. Fix each problem in the order listed. Sometimes, fixing
one problem will cancel the following ones. To avoid any confusion or wasted
time, click Re-Verify after correcting each problem.
Run time When you run your job, Label Studio will first verify your whole job all over
again. A key reason for this final check is that some job errors might not have
been detected earlier. This is possible especially if you use Label Studio in a
network setting.