Specifications

Printer functions
\text\da590\printer functions 5.5 DA590 Instruction Manual
An explanation of the menu fields
SETTING Selection of a user-defined set-up.
You may create various set-ups yourself and store these as a “setting”.
Nine of the ten setting options, “No 1” - “No 9” are available for user
defined set-ups. The first option, “No 0”, is reserved for factory default
settings.
If you select setting “No 0”, programming mode is terminated
immediately after pressing the “enter” key. You cannot make any
changes to setting “No 0”.
To make changes to a set-up, you must first select any one of the
remaining nine options (“No 1” to “No 9”) or use the default “No 1”.
By ending programming mode, the changes that were made are
automatically stored in the selected setting “No #".
The settings remain stored when the printer is switched off.
In the “service” option “SetD”, you can print out the active
settings (see “service” description).
A default reset may be accomplished by holding down the
“prog” key while turning on the printer.
FONT Selection of the font (see section “Fonts”). Three fonts, Cour12,
Helv14 and TmsRm12 are resident in the printer.
PRINT QUALITY Selection between two print qualities: NLQ and LQ
NLQ: Near Letter Quality = 150 dots printed per inch
LQ: Letter Quality = 300 dots printed per inch
CHAR.
SPACING
The space between characters can be adjusted from 0 to 30 dots.
CHAR. HEIGHT Characters may be printed normal, double and triple high.
CHAR. WIDTH Characters may be printed normal, double or triple wide.
LINE SPACING Line spacing may be from 1 to 10 lines per inch.