Instruction manual

\text\etd\DA608\maintenance F.1 DA608 instruction manual
F. Printer Maintenance
Notes on maintenance
WARNING! To help avoid personal injury or damage to the equipment;
Power the printer off and unplug the power cord from the printer, before
performing any maintenance tasks.
Rubber Roller Parts:
Ensure that the rubber contact wheels and rollers are kept clean at all times. The use
of Rena Care (rubber roller cleaner) is recommended to clean the rubber roller parts
in your printer. Please be sure that Rena Care is not placed on sensors, electronics
and plastic parts or damage will result.
Rena Care (part # 2024) can be purchased from your local Rena Dealer.
Paper Sensor:
The paper sensor should be cleaned using compressed air and a soft bristled brush.
Do not use liquids to clean the paper sensor or damage may occur. The paper
sensor is located just before the print area, centered in the table top. It is a reflective
sensor that looks up at the underside of the media (mail piece).
Body of Printer:
The table top and body of printer can be cleaned with a cloth, dampened with water.
A mild detergent may also be used.
Proper inkjet cartridge cleaning & storage techniques
Including Wiper Maintenance Information
CARTRIDGE CLEANING
In order to maintain print quality, at its highest level, the Rena DA608 printer automatically
cleans the inkjet cartridge nozzles:
• Every time the printer is powered on.
• Every time the printer is placed on-line, from the off-line condition.
• Before every TEST address is printed.
• After every few hundred addresses are printed (user selectable in the DA608).
+
In some cases it may be necessary to remove and
manually clean inkjet cartridges.
In the DA608 printer the Cartridge Purge Feature is
also available to help clear inkjet nozzles.
+
CARTRIDGE PURGE FEATURE:
The printer’s “Head Recovery” feature can be used to help un-clog print
nozzles. Pressing the START and Back Space (Repeat Address(es)) keys
together will cause the printer to do a “Head Recovery”.