Instruction manual

Error messages and information
\text\etd\DA608\error 8.2 DA608 instruction manual
Error message Cause Solution
CHECKSUM ERROR !!
MAKE DEFAULT RESET
Error in the buffered
RAM (module M48Z58).
– Reset to default value (see
Sect. 5).
– Replace module M48Z58.
CHECKSUM ERROR !!
MAKE COUNTER RESET
CHECKSUM ERROR !!
MAKE DEFAULT RESET
CHECKSUM ERROR !!
MAKE DEFAULT RESET
TEST MACRO TOO LONG
The user-defined test
address is too long.
Limit the size of the test
address to 3 Kbytes.
BUFFER OVERFLOW !!
Error in data transfer. Check connections of the
interface cable.
EPROM ERROR !!
VERIFY FONT
Error in the Flash prom. Reload the RENA fonts.
EPROM ERROR !!
VERIFY PROG
Reload the program
(firmware).
RAM ERROR !!
VERIFY RAM
Error in RAM. Have the CPU board
replaced by service
personnel.
PROGRAM ERROR !!
MAKE DEFAULT RESET
Error in program
execution.
- Perform a default ini-
tialization (Sect. 5)
- Reload the firmware.
SAVE INPUT DATA !!
Address was not printed to
the end.
Make no changes in
programming mode when
the print job is running!
PIC ERROR
VERIFY CONTROLLER
Error in controller module
that controls the paper
transport.
- Check module PIC 1665.
- Set the paper feed
mechanism properly.
PIC ERROR
VERIFY CONTROLLER
PIC TIME OUT
VERIFY CONTROLLER
PIC STATUS ANSW.
PAPER OUT (PAP)