Instruction manual

\text\etd\DA608\error 8.1 DA608 instruction manual
8. Error messages and hints
Usual error messages
Error message Cause Solution
ERROR LCA !!
CALL SERVICE
Error in loading the
hardware into the XC5206
module.
- Check the connection on
or to the print board.
- Check the module.
ERROR LCA Ready
CALL SERVICE
Printing error – the XC5206
module does not confirm
successful completion of print
operation.
XC5206
- Check the printhead.
- Check that the correct
firmware was loaded.
PRINTHEAD ERROR !!
CHECK HEAD MOVEMENT
The printhead fails to
reach its end position.
Problem with home sensor
Check the printhead.
Check home sensor.
HEAD INTERRUPT ERR !!
START&PROG TO CONTINUE
The printhead is jammed.
No signal from encoder.
Encoder strip is out of
sensor.
Check the encoder strip to
be sure it is within the
sensor, located on the back
of the printhead carriage.
NO PAPER !!
Paper has run out. Insert new paper (see Sect.
3).
PAPER JAM !!
REMOVE PAPER
Paper is jammed.
Paper is not properly
separated (overlapped).
Wrong paper size set.
Remove jammed paper and
readjust the paper feed
mechanism (see Sect. 3).
Make sure paper size is set.
POSITION ERROR !!
CHECK TOP MARGIN
The printed area is outside
the paper format.
The light barrier for paper
detection is not working
properly.
Dark colors on underside
of mail piece. See below.
Check the light barrier.
Reduce the "Top margin"
setting with the "ð" key or in
programming mode, or
correct the paper size (see
Sect. 5).
Check the paper for black
areas.
ADDRESS TOO LONG
CHECK TOP MARGIN
Address does not fit onto
the paper.
No form feed.
Dark colors on underside
of mail piece
Reduce the "Top margin"
setting with the "ð" key or in
programming mode, or
correct the paper size (see
Sect. 5).
Send FF from software.
Set paper size and set
“paper sensor” feature “off”.
NO INK !!
CHANGE PRINTHEAD
Ink monitor = %0.
Cartridge may be empty.
Replace the cartridge (see
Sect. 4). Do “Head Reset”.