Instruction manual

Printer functions
\text\etd\DA608\printerf 5.11 DA608 instruction manual
Special Funct.
Bit8 Set To
This menu allows you to define how the DA608 should execute bit 8.
This menu option is active only for 7-bit character sets.
The following variants are possible:
BIT8: The higher-value bit (bit 8) of the received character is taken
over in unchanged form.
FIX0: The higher-value bit (bit 8) of the received character is
always deleted.
FIX1: The higher-value bit (bit 8) of the received character is
always set to "1".
Auto LF Automatic line feed off / on_1 / on_2 / on_3
Use this menu to define how the DA608 is to interpret the following
control characters:
CR = Carriage return
LF = Line feed
and FF = Form feed.
The following variants may be selected:
off : CR = CR, LF = LF, FF = FF
on_1: CR = CR + LF LF = LF FF = FF
on_2: CR = CR, LF = CR + LF FF = CR + FF
on_3: CR = CR + LF LF = CR + LF FF = CR + FF
Hex to ASCII HEX to ASCII CONVERSION off/on
When the conversion is switched on, the printer interprets the
percentage symbol "%" as a non-printable control character. The two
characters following the % symbol are then interpreted as HEX values
and combined into a single character.
Example: %0C = Form Feed
Line Mode Line mode off / 1 - 99 lines
This option allows address separation by a specific number of line
feeds.
If the PREV/NEXT key is kept continuously pressed, the change takes
place in steps of 10, otherwise in steps of 1.
Delimiter < > Individual page feed on/off
When the delimiter is activated, the two print characters "< >" are
recognized as the beginning and end of a page print with paper
ejection. This means that you should set the character "<" before a
piece of text that should go onto a new page and the character ">"
after the text, before the page is to be ejected.