Instruction manual

Printer functions
\text\etd\DA608\printerf 5.7 DA608 instruction manual
At the "DPBC" setting, the program searches for the house number at
the start of the street line and adds it to the ZIP barcode.
The street line must be sent to the printer before the line containing
the postal code. The house number should be at the beginning of the
line. Where the house number consists of three digits, only the last two
are converted into barcode. Addresses consisting of only a single digit
are preceded by a 0.
BARCODE
POSITION
After you acknowledge your choice in the "BARCODE OPTIONS
"
menu field, the following display appears:
"BARCODE POSITION : top"
The ZIP barcode position can be defined by the options "top", "bot" or
"conv".
These define the position of the ZIP barcode within the address block.
The following variants are possible:
top: the barcode line is printed as the first address line.
bottom: the barcode line is printed after the last address line.
conventional: the position of the barcode line is fixed.
In the “conv” option, the following settings are made:
LEFT MARGIN: 94 mm
TOP MARGIN: 51 mm
The barcode is indented by 30 mm and printed in the eleventh line, i.e.
the spacing between the first line of the address and the barcode is 10
line feeds (at 6 lpi).
The values for LEFT MARGIN and TOP MARGIN can be changed to
your requirements to match the position of the address on the
envelope.
+
Correct positioning of the address is ensured only in the
"Nor" position.
Other barcodes
If you acknowledge barcode "2/5i", "coda", "co39" or “c128” with the
ENTER key, you will be offered the following parameter setting:
"SMALL WIDTH : 6"
SMALL WIDTH You can set the width of the narrow bar from 1 to 99 (dots).
LARGE WIDTH After you have acknowledged your setting in the "SMALL WIDTH
"
menu field, the following appears:
"LARGE WIDTH : 15"
You can now set the width of the thick bar from 1 to 99 (dots) (except
for c128).
BARCODE
HEIGHT
After you have acknowledged your setting in the "LARGE WIDTH
"
menu field, the following appears:
"BARCODE HEIGHT : 50"
You can now set the height of the barcode from 1 to 999 (dots).
+
A maximum of 150 dots high can be printed with a single
movement of the printhead.