Instruction manual

Printer functions
\text\etd\DA608\printerf 5.4 DA608 instruction manual
MENU OPTION
LINE MODE off 0 1 ... 99
DELIMITER < > off on
STX-ETX off on
OFFSET EDGE 0 ... 227 [mm]
CLEANING CYCLE 50 100 200 300 1000 off
WARMING off lev1 lev2 lev3 lev4 max
CAPPING DELAY off 10s, 20s, 30s, 40s, 50s 60s
SERIAL INTERF. PC DISP
HANDSHAKE both XON DTR
BAUD RATE 19K2 9600 4800
DATA LENGTH 8Bit 7Bit
PARITY no even odd
STOPBIT 1 2
SERVICE Rev Adrc Font Ram Head Corr Char HexD InpD SetD
HARDWARE TEST -- For service use only ! --
HEAD RESET yes no (Choose yes when installing new cartridge)
The underlined values are default settings
Explaining the menu fields
Setting Selection of user configurations.
If you wish to use the DA608 in certain applications, it may be
necessary to change some menu settings. You may set up various
configurations yourself and store these in the "Setting" menu.
Nine of the 10 options "No 0" - "No 9" are available for your own
configuration.
The first option, "No 0", is reserved for the default setting.
If you select this option, programming mode is terminated immediately
after pressing the "ENTER" key. No further changes can then be made
in this configuration.
To make changes in this configuration, you must first select one of the
remaining nine options ("No 1" to "No 9"). When programming mode is
terminated, the changes made are automatically stored in the selected
"Setting No".
You can lock the setting you have made immediately by using the
key to call the “SETTING LOCKED“ option and selecting between
“yes“ and “no“ with the same key.
Warning! Locking settings will cause problems when printing from
Windows programs using a Rena driver.
The set configurations are retained when the printer is switched off.
In the "SetD" option in the “Service” menu you can print out the active
configuration (see "Service" description).
After a works initialization via the "PROG" key (at switch on) all
configurations are set to the default setting.