Instruction manual

Printing
\textetd\DA608\printing 4.3 DA608 instruction manual
Print test
Press the “TEST” key. The lowest sheet is pulled in and printed with a
test address. The sheet is then ejected and the next sheet is pulled in.
+
Never touch the internal parts of the printer while it is
running!
Counting addresses
Every print operation is counted after the paper has been ejected. The number of
print operations can be seen in the right top of the display. The printer can count
addresses in two different and independent ways.
Counting test
addresses
A count of the test addresses represents the number of test print
operations performed by the printer after the paper is ejected.
To perform this count, press the “TEST” key when the printer is in off-
line mode.
If you switch to on-line by pressing the “START” key, the count will
disappear from the display but will remain stored in the printer.
If you return to off-line mode by pressing the "START" key again and
carry out more test prints, the stored counter number reappears in the
display and counting is continued.
By simultaneously pressing the "PAP" and "TEST" keys, you can reset
the currently displayed counter number to “0”.
Counting
received
addresses
An address count represents the number of data print operations
received by the computer after the paper is ejected.
This counting takes place when the printer is on-line.
The counted number remains visible in the display until you press the
"TEST" key in off-line mode. Only when you change back to on-line
mode does the counted number of the received data-print operations
appear in the display again.
If you return to data transfer with printing, the counting is continued.
By simultaneously pressing the "START" and "PAP" keys, you can
reset the currently displayed counter number to “0”.
+
Both address counters are reset when the printer is switched off!