Instruction manual

Addressing paper
\text\etd\DA608\addressing 3.3 DA608 instruction manual
Setting page
guides
– Loosen the fixing screws (a) and then adjust the feed brackets
(1 and 2) to the width of your document (3).
CAUTION !
The paper must cover the paper detector.
Adjust the position of the feed brackets with respect to the paper
detector. The paper edge should project at least 5 mm at the sides
beyond the paper detector.
address
paper
detection
1
3
2
a
If the installed feed bracket (2) is not wide enough, then exchange
it for one of the two wider ones supplied with the printer.
– Loosen the fixing screws (a) and lift the feed bracket (2) from
the opening.
– After inserting the new feed bracket, adjust it to the desired
width and fix it in place with the screw (a).