Instruction manual

printing
\text\da590\printing 3.3 DA590 Instruction Manual
Changing the blotter roll
When the surface of the blotter roll stops blotting because it can’t absorb any more
ink, simply peel one layer of the paper away and tear it off.
Replacing the blotter roll
When the entire blotter roll has been used up, switch off the conveyor to replace it.
Remove the entire magnetic arm (9) from the conveyor. Pull the cardboard tube (a)
with the roll holder (b) still inside it, from the roll arm assembly bar (c). Tear off the
cardboard tube. Push a new blotter roll (d) onto the roll holder (b). The roll holder
should be inserted midway into the blotter roll. Then slip the blotter roll and holder
onto the roll arm assembly bar. Make sure that the open end of the paper is facing in
the right direction (e). Turn on the conveyor to check the operation of the blotter roll.