Instruction manual

printing
\text\da590\printing 3.2 DA590 Instruction Manual
Operating the conveyor
The conveyor is turned on or off by pressing the power switch (10). The speed may
be adjusted faster or slower by turning the speed control potentiometer knob (3). The
minimum speed is (135 mm per sec.) about 5
1
/
2
” per second and the maximum speed
is (448 mm per sec.) about 17
1
/
2
” per second.
Optional blotter roll
The TB-356 may be used with an inkjet printer. With some material, ink drying time
may be so long that the ink smears when the piece is dropped into the stacker (high
gloss stock, varnished stock etc.). In these cases, the optional blotter roll and holder
will be helpful. The blotter roll must be placed over the exit/drive roller at the end of
the conveyor (see Note 1 below). The printed material passes under the revolving
roll and excess ink is blotted dry.
Note 1: If the blotter roll is placed anywhere other than directly over the exit/drive roller, it may cause the
transport belts to move out of position causing damage to the belts or the drive motor.