Instruction manual

Power connection
\text\da590\power N.1 Power input module
Power connection
CAUTION !
Before plugging the power cable into the back of the printer check for the
correct voltage setting on the power input module.
If the setting is correct, go on to the sub-section on the “power cable”.
Voltage selection
- Remove the power cable!
- Open the (housing) lid (a)
at the slit (see arrow) with
a small screwdriver or
similar tool and place the
fuse mount carefully to one
side.
- Pull the voltage selection
card (c) straight out of the
housing via the indicator
pin (b).
- Turn the voltage selection card until the desired voltage can be read at the
bottom edge.
- The indicator pin must be placed in the relevant space in the card and must
point upwards.
- Insert the voltage selection card with the printed side toward the IEC plug
into the housing and align the indicator pin with the housing marking.
- Replace the (housing) lid and check that the indicator pin is placed in the
opening with the desired voltage specification.