for Professionals REMS Amigo REMS Amigo E REMS Amigo 2 REMS Amigo 2 Compact REMS Amigo 22 V eng Instruction Manual ............................................4 REMS GmbH & Co KG Maschinen- und Werkzeugfabrik Stuttgarter Straße 83 71332 Waiblingen Deutschland Telefon +49 7151 1707-0 Telefax +49 7151 1707-110 www.rems.
5 1 11 8 9 10 Fig. 4 12 13 11 Fig.
Fig. 7 4 3 2 7 8 9 22 23 14 Fig. 8 1 5 6 24 Fig.
eng eng Translation of the Original Instruction Manual Fig.
eng eng ● Avoid intensive skin contact with thread-cutting materials because of the degreasing effect. Use skin protectors with a greasing effect or a suitable hand protection. ● Never let the power tool operate unattended. Switch off the power tool and pull out the mains plug during longer work breaks. Electrical devices can cause hazards which lead to material damage or injury when left unattended.
eng eng Total discharging due to storage If a relatively low charged Li-Ion battery is stored, self discharging can lead to total discharge damage of the battery after longer storage. Li-Ion batteries must therefore be charged before storing and recharged every six months at the latest and charged again before use. Input 100 – 240 V~; 50 – 60 Hz; 90 W – Output 21.6 V --all-insulated, interference-suppressed Rapid charger Input 100 – 240 V~; 50 – 60 Hz; 290 W – (accessory art. no. 571587) Output 21.
eng If a thread is to be cut on a short length of laid pipe, the quick-change die heads S of the REMS eva must be used with an additional pipe guidance (19) on the cover side. If a thread is to be cut on a short length of laid pipe, the REMS quick-change die heads S must be used with an additional guide sleeve (19) on the cover side. WARNING Do not use the REMS quick-change die heads S together with extension (Art.-No. 522051) with an electric die stock for cutting threads.
eng eng 5. Faults 5.1. Fault: Electric die stock does not pull through, overload protection (10) triggers off. Cause: Remedy: ● Not original REMS quick-change die heads. ● Only use REMS quick-change die heads. ● REMS dies are blunt. ● Change REMS dies, see 2.3. ● Unsuitable thread-cutting material. ● Use REMS Spezial or REMS Sanitol thread-cutting oils. ● Worn carbon brushes. ● Have the carbon brushes or DC motor changed by qualified personnel or an authorised REMS customer service workshop.
