Specifications

InstallationLocation:

TheThermostatisrestrictedtobeusedinindooronly.Itshouldbemountedonaninnerwallabout

1.5m(5ft)abovetheflooratapositionwhereitisreadilyaffectedbychangesofthegeneralroom

temperaturewith freely circulating air. Avoid mounting above or near hot surfaces or

 equipment

(e.g. TV, heater, refrigerator). Avoid mounting where it will be exposed to direct sunshine, drafts,

or in a laundry room or other enclosed space. Do not expose this unit to dripping or splashing

liquids.



PhysicallyInstallingtheThermostat:

1. OpentheZTS‐110bypullingthetwosectionsapart(Figure2).Usethefingertipsofonehandto

gripthetabonthefronthousing.

2. Applypowertothethermostat:

a) Forbatterypower,installfourAAbatteries(alkalinerecommended).Matchthepolarity

ofthebatterieswiththe

+/‐marksinsidethebatterycompartment.

b) For24Vacpower,connectthewiresasdescribedin"Wiring"

3. Insertthetwoincludedwallanchorsintothewall,alignedwithtwoofthemountingholesin

thebackhousingofthethermostat.

4. Fastenthebackhousingtothewallusing

thetwoincludedmountingscrews.Insertthescrews

throughthemountingholesinthehousingandintothewallanchors.(Figure3)

5. Alignthefronthousingofthethermostatwiththebackhousingandpushuntilthehousing

sectionsarelockedtogether.

Figure2.OpenZTS‐110

Figure3.Installthefronthousing