Specifications

29
3
IftheZTS‐110isaddedintothe
networksuccessfully,thesignalof
“done”willappear.
4
Press “Home＂ keyoncetogo
backtothehomepage.
 willappearonthemain
display.

Note:
z ItisrecommendedtoperformtheDelete/ExcludeprocedurebeforedoingAdd/Include.Thisisto
makesuretheZTS‐110isnotinanyotherZ‐WavenetworkwhichwillresultinfailureinInclusion
process.
z Iftheinclusionisfailed,tryexclusion,and/orresetZTS‐110tofactorydefaultandtryinclusionagain.
z AfterZTS‐110isincludedtoZ‐Wavenetwork,itwillstayinEasymodebydefault.
z YoucanenableordisableEasymodebylocal“SettingMode”orZ‐Waveparameternumber8.
 (pleaserefertoparametertableatZ‐WaveConfigurationParameters).

Delete(Exclude)ZTS‐110fromGateway/ControllerZ‐Wavenetwork

Step Procedure/Description LCDindication
1
Gateway/Controllerdeviceshould
besettoExclusionmode.

Pressandhold “Home”keyfor2
secondstosetZTS‐110toAdd
(Include)/Delete(Exclude)Mode.
2
Press “Prog＂ keyonce, itwill
searchthenetwork.
3
IftheZTS‐110isremovedfromthe
network,itshowsnoconnection.