Specifications

28

Important:
Pleasenotethebelowscenariosforpowerapplyingbecauseitwillaffectthebatterylifeifthestepsare
notcorrect(thisisalsomentionedatPhysicalInstallationandWiringsectioninthisusermanual):
a) If it is powered by batteries or powered by batteries firstthen appliedwith 24Vac
 beforeZ‐Wave
inclusion,ZTS‐110willself‐configuretoFLiRSmodewhichwillsavebatterylifebysleeping.
b) If it is powered by 24Vac or powered by 24Vac first then applied with batteries before Z‐Wave
inclusion,ZTS‐110willself‐configuretoAlwaysListeningModewhichwill
notsleep.
c) After inclusion process, ZTS‐110 will not detect power source and not allow changing operation
mode.YoumustperformexclusionprocessfirstifneedtochangeZ‐Waveoperationmode.
d) After Z‐Waveinclusion process,if you resetZTS‐110todefaultwhileboth24Vac andbatteries
are
applied, ZTS‐110 will take 24V ac as primary power source and self‐configure to Always Listening
Mode, because reset to default process will automatically exclude ZTS‐110 from the Z‐Wave
network.You should disconnect the powersource and re‐apply the power so ZTS‐110can detect
the
powersourcetypeandself‐configuretocorrespondingmode.
Remark:
‐ If you are using battery and somehow it is in Z‐Wave Always Listening Mode, or if you are using
battery as back up, and the AC power is down, the battery will drain very fast (battery will only
survive
3‐5days).
‐Reg ardlesstheFLiRSmodeorAlwaysListeningMode,thesetupandoperationsaresame,andyou
canalsouselocalcontrolwhileisitincludedtoZ‐Wavenetwork.


Z‐WaveAdd(Include)/Delete(Exclude) into/fromZ‐Wavenetwork

Add(Include)ZTS‐110toGateway/ControllerZ‐Wavenet work


Symbol InclusionandExclusionModeKeyDescription

Add(Include)/Delete(Exclude)
Step Procedure/Description LCDindication
1
Gateway/Controllerdeviceshould
besettoinclusionmode.

Pressandhold “Home”keyfor2
secondstosetZTS‐110toAdd
(Include)/Delete(Exclude)Mode.
2
Press “Prog＂ keyonce, itwill
searchthenetwork.