Specifications

27
ShortCycleStartUpProtection
Toprotectthecompressor/Heatpump,thoseoutputsforcedoffuntil3minutescountdown
finished.Thoseoutputscanbeactivatedaccordingtotheroomtemperatureafter3minutes.
System Output
NonHeatpumpsystem Compressor
Heatpumpsystem 1ststageheatandcompressor

EnergySavingMode
Step Procedure/Description LCDindication
1
Usercanenable/disableenergy
savingmodebyusingZ‐Wave
BASICsetcommandonly.(youmay
refertotheZ‐Waveprimar y
controllerUIforit)

=>Enableenergysavingmode
 Basicsetvalue=0x00(Off)
 (energysavingmodewillbemapped
 tooffmode)

=>Disableenergysavingmode
 Basicsetvalue=0xFF(Resume)
 (comfortmodewillmappedto
 resumemode)


Z‐WaveSetupandOperations
SettingFLiRSorAlwaysListeningmode
• SettingtoZ‐WaveFLiRSmodewithbatteriesaspowersource
ZTS‐110willself‐configuretoFLiRSmodeifitispoweredbybatteriesorpoweredbybatteriesfirst
then applied with 24Vac before Z‐Wave inclusion. FLiRS mode is targeted for battery operat ed
applicationsandwillentersleepmodefrequentlyinordertosavebatterylife.ZTS‐110can’tact
as
a repeater in this mode. The response to Z‐Wave command is not as quick as Always Listening
Device.Normallythereis1‐2secondslatencyonresponse,youshouldavoidsendingcommandsto
ZTS‐110toofrequently.

• SettingtoZ‐WaveAlwaysListeningmodewith24Vacaspowersource
ZTS‐110willself‐configuretoAlwaysListeningModeifitispoweredby24Vacorpoweredby24Vac
firstthenappliedwithbatteriesbeforeZ‐Waveinclusion.AlwaysListeningmodeistargetedforAC
power operated applications and it can act as a repeater which will re‐transmit the RF
 signal to
ensurethatthesignalisreceivedbyitsintendeddestinationbyroutingthesignalaroundobstacle
andradiodeadspots.TheresponsetoZ‐Wavecommandisimmediate.
