User's Manual
25
3
- The “✔” symbol will be displayed on screen
once the ZTS-500US is added into the network.
The Z-Wave disconnect icon will also be
removed from the standby screen.
- The “x” symbol will be displayed on screen if
there is no action (time out) or unable to include
the ZTS-500US into the network.
Notes:
1. It is recommended to perform the Remove/Exclude procedure before performing an
Add/Include procedure. This will ensure the ZTS-500US is not in any other Z-Wave network
which will disrupt the inclusion process.
2. If the inclusion process fails, try exclusion and/or resetting the ZTS-500US to factory default and
try inclusion again.
3. If the user navigates the menu from Brightness to the right side, the Z-Wave menu will be
skipped if the ZTS-500US is already included into the network and it will loop back to the
Standby screen by pressing the > key.
Remove (Exclude) ZTS-500US from Gateway / Controller
Step
Procedure / Description LED indication
1
Press and keep holding > or < for 3 seconds to
navigate to the System Main (SYS) screen.
On the Z-Wave (Z-w) screen, press + or – to entry
the setting.
2
Tap + to exclude or include ZTS-500US from or into
the network.
Press < to cancel and back to the previous screen.
3
There is a “z” animation during Z-Wave searching.
.
.