User's Manual

Z-Wave Add (Include) / Delete (Exclude) into/from Z-Wave network
Add (Include) ZTS-110 to Gateway / Controller Z-Wave
network
27 28
LCD indicationStep Procedure / Description
Gateway / Controller device should be set to
Exclusion mode.
Press and hold "Home" key for 2 seconds
to set ZTS-110 to Add (Inclusion) / Delete
(Exclusion) Mode.
1
Press "Prog" key once, it will search the
network.
2
If the ZTS-110 is removed from the network,
it shows no connection. Exclusion is
completed.
3
Press "Home" key once to go back to the
home page.
will appear on the main display.
4
WAKE
AM
PROG ON
MO
FAN AUTO
OFF
Inclusion and Exclusion Mode Key DescriptionSymbol
Add (Include) / Delete (Exclude)
LCD indicationStep Procedure / Description
Gateway / Controller device should be set
to inclusion mode.
Press and hold "Home" key for 2 seconds
to set ZTS-110 to Add (Inclusion) / Delete
(Exclusion) Mode.
1
Press "Prog" key once, it will search the
network.
2
If the ZTS-110 is added into the network
successfully, the signal of "done" will
appear.
3
Press "Home" key once to go back to the
home page.
will appear on the main display.
4
WAKE
AM
PROG ON
MO
COOL
FAN AUTO
Note:
- It is recommended to perform the Delete/Exclude procedure before doing
Add/Include. This is to make sure the ZTS-110 is not in any other Z-Wave
network which will result in failure in Inclusion process.
- If the inclusion is failed, try exclusion, and/or reset ZTS-110 to factory default and
try inclusion again.
- After ZTS-110 is included to Z-Wave network, it will stay in Easy mode by default.
- You can enable or disable Easy mode by local "Setting Mode" or Z-Wave
parameter number 8.
(please refer to parameter table at Z-Wave Configuration Parameters).
Delete (Exclude) ZTS-110 from Gateway / Controller Z-Wave
network