Operating instructions

21-1780-7D001/E-05/2013-BEH-D278563
Practical example
The following components were used: HSB, AC 254 V, 10 W/m, cold-
applied connection and termination technology, BARTEC Polyester
junction box; It was filled in according to the grey-shaded line in the
HSB table.
Reservation
Technical data subject to change without notice. Changes, errors and misprints may not be used as a basis for any claim for damages.
EN 9/16
Requirements set for connecting terminals
Rated cross-section min. 6 mm²
Working temperature -55 °C up to +100 °C (HSB)
-40 °C up to +100 °C (MSB)
Minimum distance
between conducting
terminals and wall 25 mm
Requirements set for the cable gland
Working temperature -55 °C up to +70° C (HSB)
-40 °C up to +70 °C (MSB)
Requirements set for connecting terminals
Material
Polyester
Aluminium
Stainless Steel
External dimensions of enclosure
1 Heating circuit min. 122 x 120 x 90 mm
1 - 3 Heating circuits min. 220 x 120 x 90 mm
Ambient temperature -55 °C up to +55° C (HSB)
-40 °C up to +55 °C (MSB)
Protection class EN/IEC 61241-0 min. IP 65
Non-BARTEC enclosure
If an enclosure from another company is used, all requirements
specified in the checklist must be fulfilled.
The enclosure material is limited to the selection indicated. The
external dimensions of the enclosure must conform to the specific
minimum dimensions. Certification of “e“ increased safety type of
protection in compliance with EN 60079-7 must be presented for all
components.