Installation guide

44
Accessories
RM-433
The RM-433 is a radio frequency receiving device for
communicating to RTI control systems and operates at
433MHz. The RM-433 contains a microprocessor that
monitors all received signals so that RF noise is filtered
out. When valid RF data from an RTI remote is detected,
the RM-433 passes the signal through its output driver
which allows the data to travel long distances over wire.
The output driver is compatible with industry standard
infrared repeating systems, and can be wired together
with those systems or with additional RM-433 units.
Part #: 10-210039-16
• Reliable RF reception due to matched antenna, connector, and
PCB.
• Modular design that allows multiple RM-433 units to be wired
together allowing for nearly any desired coverage area.
• Output signal is compatible with industry standard infrared
repeating systems. This allows multiple IR and/or RF receivers to
be wired together into an RTI control system.
• No dedicated power supply required. Power is derived directly from
the RTI control system.
• A feedback LED conrms operation.
NOTE: A 433MHz enabled remote control must be used with this
model of antenna.
Key Features
Specifications
Power Requirements ......................................... +9VDC to +16VDC @ 60mA
RF Carrier Frequency .................................................................. 433.92 MHz
Output Drive ........................................................................ 200mA maximum
Operating Temperature ......................................................... +32°F to +122°F
..................................................................................................(0°C to +50°C)
Operating Humidity .............................................. 5% to 95% non-condensing
Module Dimensions (HxWxD) . 3.5in (89mm) x 3.4in (86mm) x 1.0in (25mm)
Antenna Length ...................................................................... 13 in” (330mm)
Weight .............................................................................. 4.4 oz. (125 grams)
RF Receiver
Module
RCM-12
With twelve individually addressable relays and an
adjustable device ID, the RCM-12 Relay Control
Module provides relay control for projects of any size.
An IR input allows the RCM-12 to be triggered
from many different sources, including RTI in-wall
controllers, control processors or third-party infrared
repeater systems. IR commands trigger open and
close functions as well as adjustable hold times for
momentary relay operation.
Part#: 10-210150-10
Key Features
Relay Control
Module
• Twelve individually addressable relays.
• Relays capable of switching up to 28VDC@5A.
• Discrete set of IR codes and an IR input allows relays to be
triggered from virtually any IR programmable system.
• Relays can be used in a normally open or normally closed
conguration.
• Relays create a “dry contact”.
• Programmable momentary relay hold times.
• Adjustable device ID for installations that require more than twelve
relays.
• 12VDC power supply included.
Specifications
Power Supply .............................................................................+12VDC, 1A
Infrared Input .....Compatible with industry-standard repeaters and receivers
Relays .............................................................................Twelve, 28VDC@5A
Control Port ..................................................................................... IR/Power
Device IDs ........................................................................Ten , Rotary switch
Mounting .............................................................Wall-mount or free standing
Dimensions (W x H x D) ... 8.25in (209mm) x 5.2in (132mm) x 1.3in (33mm)
Weight ......................................................................................... 2 lb. (907g)
Warranty ................................................................. One Year (Parts & Labor)