User's Manual

T2-C Universal System Controller
14
If the light sensor is enabled, there are two backlight levels to
adjust. Press the left arrow or right arrow buttons to adjust. Press
the OK button when finished.
With the light sensor enabled, the backlight brightness will
automatically change between the two levels, depending upon the
ambient lighting conditions.
Introduction
7
GETTING STARTED
Start by inserting the battery connector into the mating plug on
the T2-C. Make sure the connector is oriented properly before
attempting to insert it. Next, turn the unit on by sliding the power
switch into the “ON” position (toward the battery).
After power is applied, the T2-C will take approximately ten
seconds to load the operating system, the application software,
and the user program. This long delay only occurs from a power-
down state. During normal use the T2-C turns-on instantly from
its sleep mode.
The T2-C is turned-on by touching any area of the display or any
keypad button. If the tilt sensor is enabled, picking up the unit
will also turn it on.
Power
Switch