User's Manual

T2-C Universal System Controller

BATTERY AND DOCKING STATION

The T2-C uses a Lithium-Ion rechargeable battery. This battery

does not exhibit any type of “Memory Effect” from being charged

too often. Since the T2-C can safely be charged after each use, a

docking station is included for convenience. If left out of the

docking station, the T2-C will remain in sleep mode for 1 – 2

months before shutting down. At that point the battery must be

recharged.

The T2-C Docking Station can be placed on a flat surface such as a

shelf or table, or it can be mounted to a wall using the mounting

holes on the back of the unit.

If the T2-C battery capacity is reduced to approximately 25

percent, a low battery icon will appear in the top center of the

display:

The low battery icon will change color to red if the battery

capacity becomes critically low:

At this point the T2-C must be placed into the docking station to

recharge the battery.

The docking station LED illuminates to indicate a charge in

progress. The LED will turn off when the battery in the unit is

fully charged.

A fully discharged battery will take approximately 2-4 hours to

completely re-charge.

The T2-C can remain in the docking station indefinitely without

damage to the battery.

Operation

TIME OUT

This button displays a window that allows you to adjust the

amount of time the unit stays awake after the last button press.

The time is variable from 1 second to 120 seconds (the default is 10

seconds). Press the arrows to the left or right of the Time Out

setting to adjust the time. Press the OK button when finished.

This setting can have a significant effect on the run-time of the T2-

C between battery charges. During Sleep mode, the T2-C uses

virtually no battery power.