Getting Started Guide
1. Part15.19
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
IC
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1)this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
2. Part15.21
WARNING: This equipment may generate or use radio frequency energy. Changes or modications to this equipment may cause
Harmful interference unless the modications are expressly approved in the instruction manual. The user could lose the authority
to operate this equipment if an unauthorized change or modication is made.
3. Part15.105
For a Class B digital device or peripheral, the instructions furnished the user shall include the following or similar statement, placed in a
prominent location in the text of the manual:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-. Reorient or relocate the receiving antenna.
-. Increase the separation between the equipment and receiver.
-. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-. Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with minimum 20 cm between the radiator and your body.
Cet appareil doit être installé et utilisé avec un minimum de 20 cm entre le radiateur et votre corps.
4. SDoC information :
==============================================
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identier: XR19-RQ
Responsible Party – U.S. Contact Information
Company: Comcast Corporation
Street Address : 1701 JEK Boulevard
City, State : Philadelphia, PA
Zip Code : 19103
Contact information : +1 267 441 8185
5. Information of authentication
FCC ID: TX4XR19RQ
IC : 11438A-XR19RQ