User's Manual

I 12
Chapter 1 | Preparing to Use the Product
Recharging and Turning Power On/Off
I Recharging with an Adapter
I Turning the Remote Control Power On/Off
Control using the power switch at the bottom rear of
the remote control.
Insert the adapter cable into the cradle and then plug the other end into a power outlet.
When recharging, do so with the power switch at the bottom of the rear side of the remote
control set to [ON]. (Note, if the power switch is set to [OFF], recharging is not performed.)
1) In case of malfunction, power off and then power on product.
2) In case of malfunction, after fully charging battery, retry operation.
Note
If this remote control is subjected to excess voltage above 6.0V,
the protective circuit within the device becomes activated, thus
discontinuing normal remote control operation.
To use normally, turn the remote control OFF and ON.