User's Manual

- 3 -

Quick Start Instructions

Step 1. Plug the (4) 283M emitters (included) into the RH55A,C. Next, place the 283M emitter head next to the IR

eye on the source component to be controlled.

Step 2. Plug the RS232 Adapter Cable (if required) into the RH55A,C. Next, connect the DB9 plug to the source

component to be controlled. In some instances, a null modem converter may be required. Below is a pin-out of

the RS232 Adapter Cable.

Step 3. Plug in the power supply to the RH55A,C device.

Step 4. Follow the XTR39 Instructions, RH55A,C Addendum and follow the steps to setup the XTR39.

Information

FCC NOTICE

* Section 15.19 Labeling requirements

This device complies with part 15 of the FCC rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference and

(2) This device must accept any interference received,

including interference that may cause

undesired operation.

* Section 15.21 Information to user

The changes or modifications not expressly approved by

the party responsible for compliance

could void the user’s authority to operate the

equipment.

* IMPORTANT NOTE: To comply with the FCC RF

exposure compliance requirements, no change to the

antenna or the device is permitted. Any change to the

antenna or the device could result in the device

exceeding the RF exposure requirements and void

user’s authority to operate the device.

0197

RH55A,C RF Base Station Quick Start Installation Instructions

This document is copyright protected. No part of this manual may be

copied or reproduced in any form without prior written consent from

Xantech Corporation.

Xantech Corporation shall not be liable for operational, technical, or

editorial errors/omissions made in this document.

Document Number 08905083X1