User's Manual

Enhance your
XFINITY
®
TV
experience with the
Aim Anywhere™
Adapter!
Pair your adapter and XFINITY
Remote to get started.
Your XFINITY Remote can be paired
with the Aim Anywhere Adapter
(also known as the XR8) allowing
you to control your set-top box or
DTA even when the device is placed
out of line-of-sight (for example, in
an entertainment center or behind
your TV). XFINITY Remotes can be
identied by an XR model number on
the back of the remote.
See the “Compatible Devices” section
on the back of this user guide to
verify that your set-top box or DTA
and remote are compatible with the
adapter.
To pair your XFINITY Remote with
the Aim Anywhere Adapter, follow the
steps below.
HERE’S HOW:
1. Turn on your TV and set-top box
or DTA.
2. Plug the Aim Anywhere Adapter
into the IR Input port* located on
the rear panel of your set-top box
or DTA.
*Note: This port may also be la-
beled IR, IR-In, IR Receive, or EXT
IR IN.
3. Wait 3-5 seconds for the solid red
LED on top of the adapter to turn
off.
It’s simple to pair your XFINITY Remote with
the Aim Anywhere Adapter.
XFINITY Remote
Aim Anywhere Adapter
USER’S GUIDE
XFINITY Remote
Aim Anywhere Adapter
USER’S GUIDE
4. Press and release the PAIR button
on the back of the adapter. The LED
on top of the adapter will turn on
when the PAIR button is pressed.
5. Press and hold the Setup button
on your XFINITY Remote until the
remote’s LED changes from red to
green. Then, press and release the
XFINITY button.
Note: You must press the PAIR but-
ton on the adapter before you press
the XFINITY button on your XFINITY
Remote.
6. If the LED on the XFINITY Remote
blinks green twice, pairing was
successful. Press CH ^ to verify that
your set-top box or DTA responds
as expected.
7. If the LED on your XFINITY Remote
blinks red, then green, and then red,
pairing was unsuccessful. Check
the “Compatible Devices” section to
verify that your set-top box or DTA
supports the Aim Anywhere Adapter.
xfinity.com
©2013 Comcast Corporation. All rights reserved.