Specifications

Commands - 105
SAVE
Commands
SYNTAX: SAVE
SAVE segment
SAVE DATA,to Flash segment, to Flash address, from RAM segment, from RAM address, length
PURPOSE: SAVE saves programs and data to flash EPROM.
REMARKS: Some cards, such as the RPC-150 and RPC-2300, only allow the first syntax, SAVE. Cards with
128K or more of flash EPROM allow saving more than 1 program. These same cards also allow
saving binary data. Refer to your hardware manual to see if it supports 128K of flash. The RPC-150
and RPC-2300 do not. The RPC-2350 does.
segment is 0 or 1, when using a 128K Flash.
address is in the range of 0 to &FFFF (65535).
A simple SAVE transferrs the program from RAM to Flash. It begins saving at Flash address 0.
SAVE segment allows you to save programs in segment 0 or 1. Programs are saved at either address
&00000 or &10000.
SAVE DATA allows you to store information POKE’d into RAM. Data should be saved above
where the program is stored to prevent clobbering.
EXAMPLE: SAVE
SAVE 1 Saves a program to Flash segment 1
SAVE DATA 1,SA,1,RA,5500 Saves data to Flash segment 1
ERROR: <Command not available> – if card does not support user serial EEPROM
<Data negative> – for address
<Data > 65.535> – for address
<21> <Hardware> - If Flash EPROM or jumper missing or bad Flash