Instructions

RIB SUN CODING INSTRUCTIONS

1. Remove the cover of your gate motor.

2. On the gate motor move DIP 1 le to ON posion (gure 1) and then DIP 3 le to ON

posion (gure 2). The programming two-colour led DL10hes green for 10 seconds.

3. In less than 10 seconds on the new remote press the buon you would like to code to the

motor.

If the remote control has been saved correctly, two-tone led DL1 (gure 3) turns red for an

instant, and a buzzer tone conrms the saved entry.

If you are coding more th

an one remote, the 10 seconds for programming the codes are

reset automaly with two-tone led DL10 thathes green to save the next remote

control.

4. Tonish programming, wait 10-15 seconds and the motor will exit learn mode. The motor

has exited learn mode when the programming led DL10 stophing.

5. Switch DIP 1 to the right (OFF) and DIP 3 to the right (OFF).

6. Test all remotes to ensure they operate the gate.

www.remotepro.com.au

PAGE 1
RIB SUN CODING INSTRUCTIONS 1. Remove the cover of your gate motor. 2. On the gate motor move DIP 1 le� to ON posi�on (ﬁgure 1) and then DIP 3 le� to ON posi�on (ﬁgure 2). The programming two-colour led DL10 ﬂashes green for 10 seconds. 3. In less than 10 seconds on the new remote press the bu�on you would like to code to the motor. If the remote control has been saved correctly, two-tone led DL1 (ﬁgure 3) turns red for an instant, and a buzzer tone conﬁrms the saved entry.