Operator's Manual
Table Of Contents
Chapter 9 Other features of the Tempus Pro
Tempus Pro User/Operator Manual - 41-2001EN-00 – Page 202
9.9.4 Fitting the printer lid (internal printer only)
If the lid becomes detached from the printer housing, refit it as follows:
1. Align the slotted ends of the lid hinges with the steel hinge pins in the printer housing:
2. Lower the lid onto the printer housing, ensuring that the top rubber seal is not trapped. Do not press
the lid into position yet:
3. (a) Hold the lid open at an angle of not more than 45° to the back of the unit.
(b) Place your thumbs on both lid hinges: