Operator's Manual

Chapter 9 Other features of the Tempus Pro
Tempus Pro User/Operator Manual - 41-2001EN-00 – Page 192
WARNING
When connected the patient name and age are not displayed.
9.6.4 Communications modes
Tempus Pro can connect to the Response Centre using a number of wired and wireless communications
interfaces e.g. Ethernet or WiFi.
Note
The Tempus can only be pre-set to connect to a single Response Centre. Configuring it to
connect to new Response Centre requires the support of RDT.
Connecting over wired interfaces such as Ethernet requires connecting the Tempus using a cable;
connecting over wireless interfaces such as WiFi require no physical connection to be made.
To make it easy to switch between these types of connections, the Tempus Pro is pre-set to connect using
different communication “Modes”. Each Mode is supported by a full set of graphical connection iAssist help
processes that provide the User with instructions specific to connecting using that technology.
The Tempus Pro shows what Mode it is in with a banner at the top of the Connection IAssist help process.
The Tempus Pro will stay in this Mode until it has been set to another Mode (even if it has been turned off
and on again).
Example Data Connection Process
Press here to
return to the
modes menu
Follow the graphical
and text instructions
to set the unit up.
Note that the set up
instructions of any
communication
devices you are
connecting to must
be followed also.
The title of the
connection
process is shown
here, this is user
configurable
Press here to
start the data
connection
process