Operator's Manual

9.6 Connecting to an alternate location
Tempus Pro User/Operator Manual - 41-2001EN-00 – Page 189
To use the Bluetooth
®
headset, follow the on-screen instructions. When the headset is turned on, the
Tempus will attempt to find it. During this time (20 seconds) a countdown will be displayed. Once the
Tempus has located the headset it will confirm this on screen before resuming with the voice connection
instructions.
Once the voice connection process has been completed, press the Dial Voice button to start the voice
connection process.
Note
When using VoIP, the voice connection may take 10-15 seconds to setup after the “Dial
Voice” button has been pressed.
Using the wireless headset
The Tempus Pro uses the Presence or VMX200 Bluetooth headset provided by Sennheiser
®
. Note that the
headset will be supplied in a charged state and its charge level is automatically maintained so long as it is
regularly docked on the charging pin on the back of the device.
It should also be noted that the headset is a Sennheiser
®
wireless device. It is supplied “paired” with the
Tempus Pro. You cannot use different wireless headsets with the Tempus Pro and RDT recommends that
you do not attempt to use the headset supplied with the Tempus Pro with any other wireless devices
(including other Tempus Pros or other communications devices such as mobile phones).
Each headset is “paired” to only the Tempus Pro to which it is attached on delivery. While attaching the
headset to other Tempus Pro units will not cause any damage, users should avoid this practise as it may
cause confusion and ultimately prevent voice calls from being made when needed.
If the headset is lost or is damaged, contact RDT for a replacement.
RDT recommends that the Sennheiser instructions (that are provided with the Tempus) are read in addition
to the instructions below.
Voice Connection Process Using the Wireless Headset
Press here to
get instructions
on using a
wired headset
Follow the
graphical and
text
instructions to
set the unit up.
Press here to
get further
instructions on
setting up the
voice
connection
The progress of
the data
connection being
established is
shown here in
place of the
patient’s
name/age