Operator's Manual

14.7 Factory default settings
Tempus Pro User/Operator Manual - 41-2001EN-00 – Page 259
Setting Range Factory Default
ECG waveform 2 Lead I-III, aVL, aVR & aVF –
4-lead ECG cable
Lead I-III, aVL, aVR, aVF & V –
5-lead ECG cable
Lead I-III, aVL, aVR, aVF, V1-6 –
12-lead ECG cable
Lead I
ECG wave speed 12.5, 25, 50 mm/s 25mm/s
ECG Gain 2, 4, 5, 10, 15, 20, 30 and 50 mm/mV 10mm/mV
ECG Monitoring filter Monitor (0.5 Hz – 35 Hz)
Filtered diagnostic (0.05 Hz – 35 Hz)
Diagnostic (0.05 Hz – 150 Hz)
Monitor (0.5 Hz – 35 Hz)
ECG Mains filter ON-OFF ON
Arrhythmia detection ON-OFF ON
Mains frequency 50-60 Hz 50Hz (this value is retained and not
reset after 8 hours or for a new
patient)
Pulse Oximeter
plethysmogram wave
speed
12.5, 25, 50 mm/s 25mm/s
Capnograph wave
speed
3.1, 6.25, 12.5 mm/s 6.25mm/s
Temperature readings ºC - ºF ºC
Invasive pressure See “6.6.4 Configuring the transducer
/ channel”.
P1 – White with arterial settings
P2 – White with arterial settings
P3 – White with arterial settings
P4 – White with arterial settings