Operator's Manual

6.3 Pulse oximetry
Tempus Pro User/Operator Manual - 41-2001EN-00 – Page 99
6.3.6 Pulse oximeter settings
Pressing anywhere in the plethysmogram area brings up the Pulse Oximeter Settings menu:
The SpCO, SpMet, SpHb and SpOC limits are only activated when their Masimo licenses have been
installed and the appropriate probes are plugged in.
Note
PI and PVI alarms are only available in Tempus Pro devices with part numbers ending in
"-R".
Menu option Menu screen
SpO2, SpCO and SpMet limits (%) – set the
upper and lower alarm limits for SpO2, SpCO
and SpMet.
SpHb limits and settings – open the SpHb
Settings menu, see “6.3.7 SpHb settings”.
HR/PR source – select ECG or Pulse
oximeter as the heart/pulse rate source.
Large pleth waveform – turn the large pleth
waveform display on and off.
Sensitivity mode – adjust sensitivity by
pressing Max, Norm or APOD.
Averaging time (s) – use the up and down
arrows to adjust averaging time in seconds.
FastSAT – turn FastSAT on or off.
Cardiac wave speed (mm/s) – change wave
speed. This setting is common to ECG, Sp02
and IP.
HR/PR beat volume - volume of the audible
tone that the Tempus emits every time a
heartbeat is detected.
SpOC limits (ml/dl) – set the upper and lower
alarm limits for SpOC.