Operator's Manual

Chapter 5 Using the Tempus Pro
Tempus Pro User/Operator Manual - 41-2001EN-00 – Page 48
5.1.4 Status bar for communications
The centre section of the status bar shows if any communications features are being used. If any
Bluetooth® devices are in use, then the Bluetooth
®
symbol will be shown and along with the number of
peripherals that are connected to the device.
Note
It does not identify the specific peripheral connected to the Tempus Pro.
If a WiFi connection is in use, then this will be shown.
If an external Invasive Pressure module is attached, then this will be shown.
The information displayed in the communications area of the status bar is based on the following priorities:
 Email – highest priority
 Response Centre communication
 Patient name & type – lowest priority
Email status bar messages
When the Summary Record of Care is being shared using email, the upper part of the status area is used to
display the connection progress whilst the lower part of the status area is used to indicate the progress
related to the Summary Record of Care report creation and sending.
The connection progress messages (upper part) may be:
 Network Connecting
 <Carrier name> e.g. Vodafone UK (only in GSM mode)
 Network Connected (only in Wi-Fi or Ethernet modes)
The SRoC report progress messages (lower part) may be:
 Creating Report
 Sending Report
 Report Sent (displayed for 30 seconds after completion)
Status bar when SRoC report is shared via email
Messages
In this example, an Ethernet
connection has been made
and the SRoC report is
being created