Operator's Manual

Chapter 3 Introduction to the Tempus Pro
Tempus Pro User/Operator Manual - 41-2001EN-00 – Page 28
Printer models
If the Tempus Pro is a printer model (part number 00-1022-R, 00-1024-R or 00-1026-R):
 The rear houses the internal thermal printer.
 Also on the rear are the camera, backlight and moveable foot.
 The RapidPak clip is absent.
 The ECG cables, SpO2 sensor and NIBP cuff are stored in the bag.
3.2.4 Tempus Pro left side
The left side of the device contains seven connectors for:
 ECG monitoring and Diagnostic ECG - green;
 NIBP - white latching connector;
 Pulse oximeter (SpO2 and pulse rate) – light grey
 Invasive pressure – white;
 Capnometer (ETCO2 and respiration rate) - yellow;
 Contact temperature (2 sockets marked T1 & T2) - turquoise.
WARNING
Do not touch the patient at the same time as touching the body or contacts of any of
the medical or communications or power connectors.
CAUTION
Consideration needs to be made to the potential for leakage currents to be created if the
Tempus or its connectors are made wet or dusty. In the event that any connectors (but
particularly patient leads i.e. ECG, Invasive Pressure, SpO
2
, contact temperature) or their
respective sockets become wet or contaminated with sand or dust, they should be cleaned
and dried before use – see “10.2.4 Cleaning the NIBP cuffs and hose”.
Connectors and their immediate surrounding areas should be clean and dry at all times.
Normally the ECG, NIBP and SpO
2
connectors will have their sensor cables attached at all times.
The Tempus’ connectors are rated IP66 in their own right and are therefore water proof and sand proof
against ingress of water or particulate into the device’s enclosure without the covers. The covers provide
(1) Rear alarm light
(2) Camera and
backlight
The Rear of the Tempus Pro (printer model)
(3) Printer