Operator's Manual

Chapter 2 Warnings and cautions
Tempus Pro User/Operator Manual - 41-2001EN-00 – Page 22
CAUTION
When using the device with GAN terminals, in order to avoid the risk of interference from the
output beam from the antenna of the terminal with the operation of the device, ALWAYS
ensure that the device is situated at least 6m behind the face of the antenna. Since the
power of the GAN terminal’s beam is high (25W approx.), care should be taken to ensure
that the antenna remains fixed and to maintain the device away from the face (and therefore
the beam) of the antenna.
CAUTION
RF energy may affect some electronic systems in motor vehicles, such as car stereo, safety
equipment, etc. Check with your vehicle manufacturer’s representative to be sure that your
product will not affect the electronic system in your vehicle.
CAUTION
Do not use the Tempus Pro’s Bluetooth
®
or WiFi communications on-board any aircraft
where its use is prohibited.
CAUTION
Take care to minimise the risk that trailing cables will be caught by passers by.
CAUTION
Prior to deployment of Tempus Pro there are settings that user organisations need to
configure. Carefully check all the relevant settings on each Tempus Pro before it is
deployed. For more information, see “4.1 Before deployment”.
CAUTION
If you use mounting systems that are not supplied or approved by RDT, we cannot
guarantee the performance of the Tempus Pro.
Note
The Tempus has been tested and found to comply with IEC/EN 60601-1-2.
Note
If all the battery lights remain off when the battery button is pressed, the battery may be in a
“deep discharge” state. The battery is not damaged when in this state but will require an
extended period on an external charger (additional 24 hours) in order to restore normal
operation.
Note
Important! The Tempus Pro is intended for use in the electromagnetic environment(s)
specified in this manual. Users of this equipment should ensure that it is used in such
environment(s).
Note
After the life cycle of the Tempus Pro and its accessories have been met, disposal should
be accomplished following national and/or local requirements.
Note
Operation of the device may be adversely affected in the presence of conducted electrical
transients or strong electromagnetic or radio frequency sources such as electrosurgery and
electrocautery equipment, HF radio transmission antenna, x-ray machines and high intensity
infrared radiation.
Note
All user and patient accessible materials are non-toxic.
Note
Hazards arising from software errors have been minimised. Hazard analysis was performed
to meet the requirements of EN14971 and IEC60601-1-4.
Note
Each external connection and part of the device is electrically isolated.
Note
Performance and safety test data are available on request from RDT, see “RDT contact
details”.