Operator's Manual

Chapter 7 Alarms
Tempus Pro User/Operator Manual - 41-2001EN-00 – Page 140
Simply press on the alarm that you wish to set and an editor will appear. This will allow you to edit both
upper and lower limits of the alarm. The editor shows the range of the alarm settings. You change the
alarm settings by simply typing in the desired value using the keypad or the up and down arrows. You can
save the changes you have made or cancel them by pressing the relevant buttons at the bottom right.
Note
The alarm limit shown is the number that the Tempus will display before the alarm is
activated i.e. in the example shown above the tempus will display when the heart rate is less
than 50 (49 or less) or greater than 120 (121 or more). The Tempus will not alarm at 50-120
inclusive. Therefore, it is possible to have the lower and upper limits set to the same value.
If any alarms are turned off, this will be shown on screen by the relevant parameter highlighted in blue.
Editing Heart Rate Alarm Limits
The alarm being
edited is shown
in the title
Change the upper
or lower limits by
typing the desired
value into the
keypad or use the
arrows
Press here to
cancel changes
and go back or
save changes
and go back
Alarms Suspended
The ECG Alarm
bar shows the
symbol for
alarms inactive
and is
highlighted in
blue