Installation Guide

1. Have your Wi-Fi network password available.

2. Insert the three D type batteries into the battery slots on the body.

3. DoorCam's status LED light should ash up and

down. If it is not, press the status button.

4. Go back to the app, and select your timezone.

5. Switch to your phone’s Wi-Fi settings, leaving your remo+ app open.

Please DO NOT CLOSE YOUR APP.

6. Connect to the network DoorCam_xxxxxx. If you

get the message “internet is unavailable”, tap “okay”.

7. Once you’re connected to the DoorCam_xxxxxx

network, switch back to the remo+ app and press

continue.

8. Select your home’s Wi-Fi network, enter the password, then press

continue. Your app will then complete the registration. This may take up to

3 minutes.

9. Secure the battery cover using a screwdriver.