Download

NOTE: The Adjustable Beard Comb has 8 length settings (1-8mm) and is designed for use on

the beard. The Adjustable Hair Clipper Comb has a further 8 length settings (9-16mm) and may

be used on long beards or on the hair on your head.

Begin with a higher numbered setting. Adjust cutting length as desired once you are familiar

with using the groomer, it is better to select a longer hair length setting in order not to trim too

much hair.

NOTE: The foil shaver is designed to shave the detailed areas around your beard, moustache

and sideburns. It is not designed to shave your entire face.

TIPS FOR BEST RESULTS

• Beard, moustache and sideburn hairs should be dry.

• Avoid using lotions before using your groomer.

• Comb your hair in the direction that it grows.

• Remove the Adjustable Beard Comb attachment if you are: defining hairline edges such as

sideburns, trimming the nape of your neck, trimming your beard line on front of neck.

• Before trimming beards, comb your hair in the direction that it grows so that the hairs are at

their maximum height and facing in the same direction.

• Since all hairs do not grow in the same direction, you may want to try different trimming

methods (i.e. upwards, downwards or across). Practice is best for optimum results.

• Use slow light pressure. Too much pressure may trim off more hair than desired.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.

• The appliance must be disconnected from the supply mains when removing the battery.

• Ensure the trimmer is discharged of all power.

• Firstly, pry the detail blade head housing using a single-side screwdriver.

• Using a small screwdriver, unscrew 2 screws on the back housing of the trimmer.

• Continuously pry the front housing using the single-side screwdriver.

• Pry the PCB holder assembly again using the single-side screwdriver from the back housing

so you can see the PCB and batteries exposed.

• Destroy the PCB holder using a wire cutter, cut the tabs on both ends of the battery assem-

bly and remove the PCB.

• Dispose of the batteries safely