Operating Guide
©2017 Pinnacle Climate Technologies 11 Vent-Free Gas Heater User’s Manual
NOTICE: This heater is intended to be used as a supplemental heating source. Use this heater along with
your primary heating system. This heater must not be used as a primary heat source. If you have a central
heating system, you may run that system’s circulating blower while using this heater. This helps to circulate
the heat around your house.
IMPORTANT: Vent-free heaters add moisture to the air, which is benecial. However, if this heater is installed
in areas without adequate ventilation, mildew may form from too much moisture in the air. See AIR FOR
COMBUSTION AND VENTILATION, pages 8 through 10.
CHECK GAS TYPE: Be sure your gas supply is right for your heater. If the supply is not correct, do not install
the heater. Contact the place where this heater was purchased for a heater appropriate for your gas supply.
NOTICE: State or local codes may only allow operation of this appliance in a vented conguration. Check
your state or local codes.
Installation
A qualied technician must install the heater. Follow all local codes.
WARNING
Never install the heater in a bedroom or bathroom; in a recreational vehicle; where
curtains, furniture, clothing, or other ammable objects are less than 36" from the
front, top, or sides of the heater; in high trac areas; or in windy or drafty areas.
WARNING
This heater creates warm air currents. These currents move heat to wall surfaces that
are next to the heater. Installing the heater next to vinyl or cloth wall coverings, or
operating the appliance where impurities in the air exist (tobacco smoke, aromatic candles, cleaning uids,
oil or kerosene lamps, etc.), may cause walls to discolor.
CAUTION