All technical modifications reserved. 02/08 TSC 08.0086 TRIPLE FOIL SHAVER 2. 4. 3. 6. 7. 5. 8. Model No. MS5120 1. 10/UK/MS5120 Version 07/10 Part No. T22-30390 REMINGTON® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries VARTA Consumer Batteries GmbH & Co. KGaA Alfred-Krupp-Str.9 73479 Ellwangen Germany www.remington-europe.com 9. © 2010 SBI MS5120 080086_REM_IFU_MS2291-2391 _UK.indd Spread 1 of 2 - Pages(1, 2, 3) 22.02.
REMINGTON® SERVICE HOTLINES United Kingdom +44 0800 212 438 (free call) Rayovac Europe Ltd, Watermans House, Kingsbury Crescent, The Causeway, Staines, Middlesex, TW18 3BA, UNITED KINGDOM www.remington.co.uk 080086_REM_IFU_MS2291-2391 _UK.indd Spread 2 of 2 - Pages(4, 5, 6) 22.02.
ENGLISH Thank you for choosing Remington ®. Our products are designed to meet the highest standard of quality, functionality and design. We hope you enjoy using your new Remington ® product. Please read the instructions for use carefully and keep in a safe place for future reference. CAUTION Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Remington ®.
ENGLISH MS5120 MS2391 – 5 mins Rechargeable Corded Full charge time 16 hours 1 hour Cordless shaving time 60 mins 60 mins Charging indicator Low battery indicator GETTING STARTED For best shaving performance, it is recommended that you use your new shaver daily for up to four weeks to allow time for your beard and skin to become accustomed to the new shaving system. CHARGING YOUR SHAVER Ensure the product is switched off.
TRIMMING (fig. E) The shaver has a 3-position trimmer. Use the trimmer push tab to extend or retract the trimmer. Completely retracted: Push the trimmer down until it locks into position. In the middle position, the trimmer works with the foils, cutting the longer, hard-to-shave hairs. Slide the trimmer into the position level with the foils. Fully extended, the trimmer can be used to trim sideburns and moustache. Slide the trimmer into the top position, above the foils.
ENGLISH Leave the shaving unit open to let the shaver dry completely. At regular interval, put a drop of sewing machine oil onto the shaving head. CAUTION: Do not clean the shaving foil with the brush. REPLACING THE FOILS & CUTTERS To ensure the continued highest quality performance from your shaver, we recommend that foils and cutters are replaced regularly. Signs that your foils and cutters need replacing: Irritation: As foils get worn, you may experience skin irritation.
Make sure the power adaptor and cord do not get wet. Do not plug or unplug the shaver with wet hands. Do not use the product with a damaged cord. A replacement can be obtained via the Remington ® Service Center. Charge, use and store the product at a temperature between 15°C and 35°C. Always unplug from the mains when cleaning or when being used under running water. Only use parts supplied or recommended by Remnigton ®.
ENGLISH Alternatively, you may choose to remove the batteries yourself: To avoid a possible electric shock hazard, unplug cord (if used) from electrical outlet and shaver. Run the shaver until the motor stops. Remove head assembly by first pressing the two side buttons. (Fig. K) Un-clip the top metal bracket by prying the lower back edge over the snap. Lift the lip of the rubber boot off the housing. (Fig. L) Pry off the front panel. (Fig. M) Remove the two screws securing the cord opening. (Fig.
