™ ™ Face &Body 2 yr GUARANTEE IPL6000FAU .
™ Thank you for buying your new Remington™ product. Please read these instructions carefully and keep them safe. Remove all packaging before use. IMPORTANT SAFEGUARDS 1 WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO PERSONS: 2 Use this appliance only for its intended use described in this manual. 3 Do not use if it is damaged or malfunctions. 4 Do not leave the appliance unattended while plugged in. 5 Keep the power plug and cord away from heated surfaces.
™ Figure1 6 7 5 8 4 9 3 10 1 17 2 11 13 18 14 KEY FEATURES 1 Power Switch 2 Power Inlet 3 i-Light Base Unit 4 i-Light Hand Piece 5 Flash Button 6 Energy Level Selection Button 7 Cool Down Mode Indicator 8 Bulb Status Indicator Display 9 Energy Level Indicator 10 Skin Sensor 11 i-Light Hand Piece Cord 12 Flash Window 13 Skin Contact Sensors 14 Nose Cone Release Buttons 15 Long-life cartridge 16 Body Treatment Head 17 Power Cord 18 Lint Free Cloth 19 Facial Treatment Head 20 Skin Contact
™ Telogen Phase (resting phase) – the hair follicle is completely at rest during this phase, which is the longest phase and lasts about 100 days. During this time, the new hairs push out the old hairs, allowing the growth cycle to begin again (fig. 4). We recommend using the i-Light Pro Face & Body system every two weeks for three treatments (for body sites) and every two weeks for four treatments (for female facial sites) to ensure you treat every active hair.
™ • • • • • • • • • • • • • • • 8 Do not more than once on the same area as this may cause burns. Do not use on the same area of your skin more than once a week. Do not use for at least 14 days following microdermabrasion treatment. Do not use if you are already undertaking permanent hair removal treatments.
™ ✹ Bulb Status Indicator Display (fig. 1-8) The device is ready to flash when the Bulb Status Indicator Display is illuminated green. NOTE: if the Flash Button is pressed AND the Skin Contact Sensor is not fully engaged OR the Bulb Status Indicator Display is not illuminated, an audible “beep” will sound. been used up and will no longer operate. You must replace the bulb cartridge to continue using the device. ✹ Treatment Head Release Buttons (fig.
™ Prepare the device for treatment 3. Unwrap the hand piece cord from the i-Light base and rest the hand piece in the base cradle. Locate the power switch on the i-Light base and ensure the unit is OFF. Connect the power cord to the i-Light base at the power inlet. Connect the power cord to the wall outlet. Turn the power switch ON. (fig. 9) 4. Use the skin sensor to unlock the unit. (fig. 6) You must unlock the unit on each body part you wish to treat 5. Select the desired Energy Level. (fig.
™ FACIAL TREATMENT ATTACHMENT ✹ Treat facial area(s) with the i-Light device (female use only) a facial treatment. ✹ IMPORTANT: The Facial Treatment Head has been specially designed to treat the unique characteristics of female facial hair. DO NOT use the body attachment on the face. See section ‘Changing Treatment Heads’ for instructions on how to exchange heads. ✹ Where you can use the facial treatment head.
™ Fig 15 Stretch Skin for Better Skin Contact – the contours of the skin may make it difficult for the skin contact sensors to be fully depressed in certain areas. You may find it easier to try and wrap your upper lip over your teeth or use your tongue to stretch your cheeks for better skin contact. To change treatment heads, please follow the instructions provided. 1. Turn the POWER SWITCH and unplug the POWER CORD from the electrical outlet.
™ • • • • • • 18 19
™ ✹ Frequently Asked Questions I have switched the unit ON, but I cannot increase or decrease the energy level. and waiting several seconds before turning it • Try resetting the unit by turning it back on. The Bulb Status Indicator Light turns green but the unit does not flash when the button is pressed. • Make sure the Skin Contact Sensor is in full contact with the skin. and waiting several seconds before turning it • Try resetting the unit by turning it back on. There is a strange smell.
™ Q. What are the risks involved with the i-Light device? Is it safe? A. The i-Light device is safe to use, but like any electronic device it is important that you read and follow the operating instructions. Q. How often should I use the i-Light device? A. You should use the i-Light device whenever you start to see hair regrowth. F DO NOT treat the same area more than once a week Q. How long do treatments take? A.
™ Q. Can I use the i-Light device if I have naturally dark skin? A. No. the i-Light device is designed to react with the dark pigment of the hair. As a result, dark brown and black skin may absorb too much of the device’s energy (heat), which may cause skin damage. Do not use the i-Light device on naturally dark skin, as it contains too much melanin. Treating dark skin with i-Light can result in burns, blisters and skin colour changes (hyper- or hypo-pigmentation).
™ H ENVIRONMENTAL PROTECTION Tanning Habits: Score 0 1 2 3 4 When did you last More than 3 expose your body to months ago sun (or artificial sunlamp/ tanning cream)? 2-3 months ago 1-2 months ago Less than a month ago Less than 2 weeks ago To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol must not be disposed of with unsorted municipal waste, but recovered, reused or recycled.
Warranty Conditions Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited WARRANTY AGAINST DEFECTS In this warranty: Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the Competition and Consumer Act 2010; CGA means the New Zealand Consumer Guarantees Act 1993; Goods means the product or equipment which was accompanied by this warranty and purchased in Australia or New Zealand, as the case may be; Manufacturer, We or us means: 1.
Contact us or the Supplier for further details. Spectrum Brands Australia Pty Ltd Chifley Business Park 1 Chifley Drive Mentone, VIC 3194 Australia Customer service in Australia: 1800 623 118 E-mail: consumer.enquiry@remington-products.com.au Website: www.remington-products.com.au Spectrum Brands New Zealand Limited Building C, Ground Floor 600 Great South Road, Greenlane, Auckland 1051 New Zealand Customer service in New Zealand: 0800 736 776 E-mail: info@remington.co.nz Website: www.remington-products.
