Operation Manual

5
5
If the moving blade has been removed this can be re-fi tted by slotting the long grooved
edge of the blade onto the two white plastic guide ridges and then seating the blade over
the plastic actuator bar. The fi xed blade is fi tted with the raised profi le pointing outwards
and fi xed with the 2 screws.
Before fully tightening the 2 screws, adjust the taper lever to the lower position and
align the blades so that their cutting edges are parallel to one another. Tighten the 2
screws. Note that if the blades are not correctly aligned then cutting effi ciency will be
impaired.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
CLEANING CAUTIONS
Cleaning should only be done with a soft brush, such as the brush supplied with the
product.
Only use the light-grade oil supplied or sewing machine oil on the blades.
Do not use harsh or corrosive cleaners on the units or their blades. Do not submerge in
water as damage will occur.
Do not wrap the cord of the charging adaptor around the appliance.
IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR
INJURY TO PERSONS:
An appliance should never be left unattended when plugged into a power outlet.
Keep the power plug and cord away from heated surfaces.
Make sure the power plug and cord do not get wet.
Do not unplug the product with wet hands.
Do not use the product with a damaged cord. A replacement can be obtained via our
Remington
®
Service Centre.
Charge, use and store the product at a temperature between 15°C and 35°C.
Always unplug from the mains when cleaning.
Only use the parts supplied with the appliance.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.