+$,5 &/,33(5 &RUG &RUGOHVV +& 0RGHO 1R +& +& +& 8. +& 9HUVLRQ 3DUW 1R 7 REMINGTON® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries VARTA Consumer Batteries GmbH & Co. KGaA Alfred-Krupp-Str. 9 73479 Ellwangen Germany www.remington-europe.
REMINGTON® SERVICE HOTLINES United Kingdom 1. 2. 3. +44 0800 212 438 (free call) Rayovac Europe Ltd, Watermans House, Kingsbury Crescent, The Causeway, Staines, Middlesex, TW18 3BA, UNITED KINGDOM www.remington.co.uk 4. 5.
ENGLISH SPRACHE Thank you for choosing Remington. Our products are designed to meet the highest standard of quality, functionality and design. We hope you enjoy using your new Remington ® product. Please read the instructions for use carefully and keep in a safe place for future reference. CAUTION Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Remington.
ENGLISH SPRACHE GETTING STARTED CHARGING YOUR HAIRCLIPPER Before using your hair clipper for the fi rst time, charge for 14-16 hours. Ensure the product is switched off. Connect the charging adaptor to the product and then to the mains. The charging indicator will light up. Your clipper cannot be overcharged. However, if the product is not going to be used for an extended period time (2-3 months), unplug it from the mains and store. Fully recharge your hairclipper when you would like to use it again.
Each comb attachment is marked accordingly on its outside middle surface surface (3mm, 7mm, 9mm, 12mm, 18mm, 25mm, left and right ear guide). Replacement combs available. Model: SP254. INSTRUCTIONS FOR HAIR CUTTING Note: For even cutting, allow the comb attachment/blade to cut its way through the hair. Do not force it through quickly. If you are cutting for the first time, start with the maximum comb attachment STEP 1 – Nape of the neck – DIAGRAM 1 Use 3 mm or 7 mm guide comb.
ENGLISH SPRACHE SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS Starting with the longest guide comb attached (25mm), cut from the back of the neck to the crown. Hold the guide comb fl at against the head and slowly move the clipper through the hair, as shown. (DIAGRAM 1) Use the same procedure from the lower side to the upper side of the head, as illustrated. Then cut the hair against the direction in which it grows and level with the sides.
If the moving blade has been removed this can be re-fi tted by slotting the long grooved edge of the blade onto the two white plastic guide ridges and then seating the blade over the plastic actuator bar. The fi xed blade is fi tted with the raised profile pointing outwards and fi xed with the 2 screws. Before fully tightening the 2 screws, adjust the taper lever to the lower position and align the blades so that their cutting edges are parallel to one another. Tighten the 2 screws.
The product contains a Nickel-Metal Hydride cell unit. Do not dispose the trimmer in household waste at the end of its useful life. Disposal can take place at our service centres or appropriate collection sites. CAUTION: Do not put in fire or mutilate your battery packs as they may burst or release toxic materials. For further information on recycling see www.remington-europe.
