Owner's manual

6
ENGLISH
, To Attach A Comb
• Holdthecombwithitsteethupward
• Guidethecombrailsintotheslotsonthesideoftheclipperhead.Thenpushthecomb
down until it seats on the adjustment arm.
, To Remove The Comb
• Holdingtheclipperwiththebladesfacingawayfromyou,rmlypushthecomb
upward and away from the blades.
A CAUTION
Iftheincorrectcombisattachedtotheproductforthedesiredcuttinglength,aredwarning
light will illuminate to indicate this.
Please inspect that the desired comb is attached or that the correct setting is selected on the
comb switch.
F INSTRUCTIONS FOR HAIR CUTTING
Note:Forevencutting,allowthecombattachment/bladetocutitswaythroughthehair.Do
notforceitthroughquickly.Ifyouarecuttingforthersttime,startwiththemaximumcomb
attachment
STEP 1–Napeoftheneck
• Setthecombto3mmor6mm.
• Holdtheclipperwiththebladeteethpointingupwards.Beginstartingatthecentreof
the head at the base of the neck.
• Slowlylifttheclipper,workingupwardsandoutwardsthroughthehair,trimmingjusta
little at a time
STEP 2–Backofthehead
 Withthecombsetat12mmor18mm,cutthehairatthebackofthehead.
STEP 3–Sideofthehead
• Setthecombto3mmor6mm,trimsideburns.Thenchangethesettingto9mmand
continue to cut the top of the head.
STEP 4–Topofthehead
• Usethelongerlengthcombattachmentandsetitto24mmor27mmthencuthairon
top of the head against the direction in which the hair normally grows.
• Forlongerhairontop,usethelongerlengthcombattachment(22–42mm)toachieve
the desired style.
• Alwaysworkfromthebackofthehead.
STEP 5 –Thenishingtouches
• Usetheclipperwithoutanattachmentcombforclosetrimmingaroundthebaseand
sides of the neck.