Instructions for use

3
Each comb attachment is marked accordingly on its outside middle surface.
INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the hair.
Do not force it through quickly. If you are cutting for the first time, start with the maxi-
mum comb attachment.
STEP 1 – Nape of the neck – PICTURE 1
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the
head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – Back of the head – PICTURE 2
ENGLISH
To attach a comb
Hold the comb with its teeth upward
To remove the comb
Holding the clipper with the blades facing away from you, firmly push the comb upward
and away from the blades.
(3-21 mm & 24-42 mm)
Set the comb attachment to 3mm or 6mm.
With the comb attachment set on 12mm or 18mm, cut the hair at the back of the head.
1mm length is achieved without any combs.
HOW TO USE
Before starting the cut
Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
Slide it onto and along the track of left and right side of the housing unit, the front of the combs
firmly sits against the clipper blade.
Comb position comb comb
1 mm 2 mm
2 mm 2 mm
3 9 mm mm
4 1 mm
30
mm
5 1 mm mm
6 1 mm mm
7 mm mm
3
6
2
5
8
2
1
33
36
39
42
4
7
Short
Long
STEP 3 – Side of the head – PICTURE 3
Set the comb attachment to 3mm or 6mm guide to trim sideburns. Then change the setting to
9mm and continue to cut to the top of the head.