Manual

Thorough Cleaning (cont’d)

TO REINSTALL THE TRIGGER ASSEMBLY:

Use the ramrod to be sure there is no charge in the barrel. See instructions on page 7.

WARNING: If there is a charge in the barrel, do not attempt to remove it by shooting it out

if you are unsure what the charge is or if you are unsure if the charge is safe. Instead, remove

the charge using the instructions on pages 21 and 22.

1. Insure the hammer is in the down or uncocked position.

2. Insert the trigger assembly into the opening in the bottom of the receiver taking care to insert the hammer

through the hammer slot. (See

Picture 24).

3. Slide the trigger assembly forward, seating the slot in the front of the trigger assembly around the trigger

assembly retaining pin located at the front of the opening. (See

Picture 26).

4. Reinstall the screw located at the rear of the trigger guard and tighten snugly by hand.

5. Reinstall hammer spur.

6. After first checking to make sure that there is no charge in the barrel and no primer in the primer pocket, check

to insure that the safety mechanism moves freely from ‘Safe’ to ‘Fire’ and back to ‘Safe’.

TO DISASSEMBLE AND CLEAN THE TORCH CAM™ BREECH BLOCK AND FIRING PIN ASSEMBLY:

Use the ramrod to be sure there is no charge in the barrel. See instructions on page 7.

1. Insure that the Safety Mechanism is in the ‘SAFE’ position.

2. Insure that the hammer is in the down or uncocked position.

3. Open the Torch Cam™ breech block.

4. Grasp the Torch Cam™ breech block from the top, placing your thumb over the rear of the firing pin, gripping

firmly. (See

Picture 27).

5. While maintaining the grip referenced above, remove the breech block screw located on the bottom of the Torch

Cam™ Breech block. (See

Picture 28).

NOTE: It is important to hold the firing pin in place while removing the retaining screw as

the firing pin assembly is under spring tension from the firing pin spring. Failure to hold the

assembly in place while r

emoving the firing pin retaining screw may result in lost parts.

Picture 26

Picture 27 Picture 28