Manual

Thorough Cleaning (cont’d)

TO REMVOVE AND CLEAN THE TRIGGER ASSEMBLY:

Use the ramrod to be sure there is no charge in the barrel. See instructions on page 7.

WARNING: If there is a charge in the barrel, do not attempt to remove it by shooting it out

if you are unsure what the charge is or if you are unsure if the charge is safe. Instead, remove

the charge using the instructions on pages 21 and 22.

1. Insure that the Safety Mechanism is in the ‘SAFE’ position

2. Unscrew and remove the hammer spur if installed.

3. With the trigger guard facing up, remove the screw located at the rear of the trigger guard, (See

Picture 23).

4. Remove the trigger assembly from the receiver by rotating the trigger assembly forward and downward, away

from the bottom of the receiver. (See

Picture 24).

5. Spray the trigger assembly with Remington Rem™ Action Cleaner to remove any residue and debris from the

trigger assembly. Shake the trigger assembly to remove any remaining Rem™ Action Cleaner from the trigger

assembly and allow to dry thoroughly.

6. Lightly lubricate the trigger assembly with Rem™ Oil at the points shown in (See

Picture 25) aking care to

remove any excess Rem™ Oil from the trigger assembly.

7. With the hammer in the rear or cocked position, cycle the safety mechanism to insure it moves freely from the

‘Safe’ to ‘Fire’ position and back to ‘Safe’.

8. Check to insure the hammer mechanism and trigger mechanism are operating properly before reinstalling the

trigger assembly into the rifle.

Picture 25

Picture 23 Picture 24